1°C Temperature Sensor with Beta Compensation
Datasheet
Chapter 9 Datasheet Revision History
Table 9.1 Customer Revision History
REVISION LEVEL & DATE SECTION/FIGURE/ENTRY
CORRECTION
Rev. 2.0 (08-10-12)
Rev. 1.36
(07-02-09)
Rev. 1.35
(04-17-09)
Rev. 1.34
(02-27-09)
Table 3.3, "SMBus Electrical
Specifications"
Added conditions for tHD:DAT. Data hold time
minimum of 0.3µs is required when receiving from
the master. Data hold time is 0µs min when
transmitting to the master.
Section 6.17, "Revision
Register (FFh)"
Added row to indicate that revision ID can be 04h.
Revision ID may be 04h or 01h.
Table 2.1, "EMC1402 Pin
Description"
In pin description table, added to function column:
“requires pull-up resistor” for SMDATA and SMCLK
pins
Table 2.1, "EMC1402 Pin
Description"
Identified 5V tolerant pins. Added the following
application note below table: “For the 5V tolerant
pins that have a pull-up resistor (SMCLK,
SMDATA, THERM, and ALERT), the voltage
difference between VDD and the pull-up voltage
must never exceed 3.6V.”
Table 3.1, "Absolute
Maximum Ratings"
Updated voltage limits for 5V tolerant pins with
pull-up resistors.
Added the following note below table: “For the 5V
tolerant pins that have a pull-up resistor (SMCLK,
SMDATA, THERM, and ALERT), the pull-up
voltage must not exceed 3.6V when the device is
unpowered.”
Table 3.2, "Electrical
Specifications"
Added leakage current.
Table 2.1, "EMC1402 Pin
Description"
“Preliminary” removed from table title
Table 5.2, "Temperature
Data Format"
Extended range for -1 updated from 001 1111 1111
to 001 1111 1000
Revision 2.0 (08-10-12)
40
DATASHEET
SMSC EMC1402