EMC1402 Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

EMC1402

1°C Temperature Sensor with Beta Compensation

SMSC -> Microchip 

1°C Temperature Sensor with Beta Compensation

Datasheet

Chapter 3 Electrical Specifications

3.1

Absolute Maximum Ratings

Table 3.1 Absolute Maximum Ratings

DESCRIPTION

RATING

Supply Voltage (VDD)

Voltage on 5V tolerant pins (V5VT_pin)

Voltage on 5V tolerant pins (|V5VT_pin - VDD|) (see Note 3.1)

Voltage on any other pin to Ground

Operating Temperature Range

Storage Temperature Range

Lead Temperature Range

Package Thermal Characteristics for MSOP-8

Thermal Resistance (θj-a)

ESD Rating, All pins HBM

-0.3 to 4.0

-0.3 to 5.5

-0.3 to 3.6

-0.3 to VDD +0.3

-40 to +125

-55 to +150

Refer to JEDEC Spec. J-STD-020

140.8

2000

UNIT

V

V

V

V

°C

°C

°C/W

V

Note:

Stresses at or above those listed could cause permanent damage to the device. This is a stress

rating only and functional operation of the device at any other condition above those indicated

in the operation sections of this specification is not implied. When powering this device from

laboratory or system power supplies, it is important that the Absolute Maximum Ratings not be

exceeded or device failure can result. Some power supplies exhibit voltage spikes on their

outputs when the AC power is switched on or off. In addition, voltage transients on the AC

power line may appear on the DC output. If this possibility exists, it is suggested that a clamp

circuit be used.

Note 3.1 For the 5V tolerant pins that have a pull-up resistor (SMCLK, SMDATA, THERM, and

ALERT), the pull-up voltage must not exceed 3.6V when the device is unpowered.

SMSC EMC1402

9

DATASHEET

Revision 2.0 (08-10-12)

Share Link: