USB2412-DZK-TR Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

USB2412-DZK-TR

2-Port USB 2.0 Hi-Speed Hub Controller

SMSC -> Microchip 

2-Port USB 2.0 Hi-Speed Hub Controller

Datasheet

Table 2.2 USB2412 Pin Descriptions (continued)

PIN

BUFFER

#

SYMBOL

TYPE

DESCRIPTION

19

SUSP_IND /

NON_REM0

16

HS_IND

24

XTALIN

I/O

I/O12

ICLKx

Active/Suspend Status LED (suspend indicator): indicates the USB

hub state. See Section 2.5, "Strap Option Pins" for details.

NON_REM0 = 0: SUSP_IND is active high

NON_REM0 = 1: SUSP_IND is active low

negated = unconfigured, or configured and in USB suspend

asserted = hub is configured and is active (i.e., not in suspend)

Non-removable Port Strap Option: this pin is sampled (in conjunction

with NON_REM1) at RESET_N negation to determine if ports [2:1]

contain permanently attached (non-removable) devices:

NON_REM[1:0] = 00: all ports are removable

NON_REM[1:0] = 01: port 1 is non-removable

NON_REM[1:0] = 10 and 11: ports 1 and 2 are non-removable

See Section 2.5, "Strap Option Pins" for details.

Hi-Speed Upstream Port Indicator

Note:

An LED can be attached for visual indication. See Section

2.5, "Strap Option Pins" for details. When an LED is not used,

this pin requires a 50 kΩ or higher resistor to ground.

negated = the hub is connected at FS

asserted = the hub is connected at HS

24 MHz Crystal Input: this pin connects to either one terminal of the

crystal or to an external 24 MHz clock when a crystal is not used.

CLKIN

23

XTALOUT

6

TEST

17

RESET_N

9

CRFILT

External Clock Input: this pin connects to either one terminal of the

crystal or to an external 24 MHz clock when a crystal is not used.

OCLKx

24 MHz Crystal Output: this is the other terminal of the crystal circuit

with 1.2 V p-p output and a weak (< 1mA) driving strength. When an

external clock source is used to drive XTALIN/CLKIN, leave this pin

unconnected, or use with appropriate caution.

IPD

Treat as a no connect pin or connect to ground. No trace or signal

should be routed or attached to this pin.

IS

RESET Input: the system can reset the chip by driving this input low,

where the minimum active low pulse is 1 μs.

POWER, GROUND, and NO CONNECTS

VDD Core Regulator Filter Capacitor: this pin can have up to 0.1 μF

low-ESR capacitor to VSS, or be left unconnected.

4

VDD33

10

14

20

27

25

PLLFILT

15

TEST1

3.3 V Power

PLL Regulator Filter Capacitor: this pin can have up to 0.1 μF low-ESR

capacitor to VSS, or be left unconnected.

This pin must be connected to VSS.

SMSC USB2412

11

DATASHEET

Revision 1.3 (12-27-11)

Share Link: