USB2514B-AEZC Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

fabricante

USB2514B-AEZC

USB 2.0 Hi-Speed Hub Controller

SMSC -> Microchip 

USB 2.0 Hi-Speed Hub Controller

Datasheet

SYMBOL

SDA/

SMBDATA/

NON_REM1

RESET_N

SCL/

SMBCLK/

CFG_SEL0

HS_IND/

CFG_SEL1

XTALIN

CLKIN

XTALOUT

Table 3.3 USB251xB/xBi Pin Descriptions (continued)

BUFFER

TYPE

DESCRIPTION

SERIAL PORT INTERFACES

I/OSD12 Serial Data Signal

System Management Bus Signal

Non-Removable Port 1 Strap Option: when enabled by package and

configuration options (see Table 5.1 on page 26), this pin will be sampled (in

conjunction with LOCAL_PWR/SUSP_IND/NON_REM0) at RESET_N negation

to determine if ports [x:1] contain permanently attached (non-removable)

devices:

NON_REM[1:0] = 00 : all ports are removable

NON_REM[1:0] = 01 : port 1 is non-removable

NON_REM[1:0] = 10 : ports 1 and 2 are non-removable

NON_REM[1:0] = 11 : when available, ports 1, 2, and 3 are non-removable

When NON_REM[1:0] is chosen such that there is a non-removable device, the

hub will automatically report itself as a compound device (using the proper

descriptors).

IS

RESET Input: the system can reset the chip by driving this input low. The

minimum active low pulse is 1 μs.

I/OSD12 Serial Clock (SCL)

System Management Bus Clock

Configuration Select: the logic state of this multifunction pin is internally latched

on the rising edge of RESET_N (RESET_N negation), and will determine the hub

configuration method as described in Table 5.1.

I/O12

Hi-Speed Upstream Port Indicator: upstream port connection speed.

Asserted = the hub is connected at HS

Negated = the hub is connected at FS

Note: When implementing an external LED on this pin, the active state is

indicated above and outlined in Section 3.3.1.3, on page 23.

Configuration Programming Select 1: the logic state of this pin is internally

latched on the rising edge of RESET_N (RESET_N negation), and will determine

the hub configuration method as described in Table 5.1.

MISC

ICLKx

OCLKx

Crystal Input: 24 MHz crystal.

This pin connects to either one terminal of the crystal or to an external 24 MHz

clock when a crystal is not used.

External Clock Input: this pin connects to either one terminal of the crystal or to

an external 24 MHz clock when a crystal is not used.

Crystal Output: this is the other terminal of the crystal circuit with 1.2 V p-p output

and a weak (< 1mA) driving strength. When an external clock source is used to

drive XTALIN/CLKIN, leave this pin unconnected, or use with appropriate

caution.

Revision 2.2 (02-17-12)

20

DATASHEET

SMSC USB251xB/xBi

Share Link: