650R-07ILF Ver la hoja de datos (PDF) - Integrated Device Technology

Número de pieza

componentes Descripción

Lista de partido

650R-07ILF

NETWORKING CLOCK SOURCE

Integrated Device Technology 

ICS650-07C

NETWORKING CLOCK SOURCE

CLOCK SYNTHESIZER

External Components

The ICS650-07C requires a minimum number of external

components for proper operation.

Decoupling Capacitor

Decoupling capacitors of 0.01µF must be connected

between each VDD and GND (pins 4 and 6, pins 16 and 14),

as close to the device as possible. For optimum device

performance, the decoupling capacitor should be mounted

on the component side of the PCB. Avoid the use of vias in

the decoupling circuit.

Series Termination Resistor

When the PCB trace between the clock outputs and the

loads are over 1 inch, series termination should be used. To

series terminate a 50Ω trace (a commonly used trace

impedance) place a 33Ω resistor in series with the clock line,

as close to the clock output pin as possible. The nominal

impedance of the clock output is 20Ω.

Crystal Information

The crystal used should be a fundamental mode (do not use

third overtone), parallel resonant. Crystal capacitors should

be connected from pins X1 to ground and X2 to ground to

optimize the initial accuracy. The value of these capacitors

is given by the following equation:

Crystal caps (pF) = (CL - 6) x 2

In the equation, CL is the crystal load capacitance. So, for a

crystal with a 16 pF load capacitance, two 20 pF capacitors

should be used. If a clock input is used, drive it into X1 and

leave X2 unconnected.

Absolute Maximum Ratings

Stresses above the ratings listed below can cause permanent damage to the ICS650-07C. These ratings, which are

standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these

or any other conditions above those indicated in the operational sections of the specifications is not implied.

Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical

parameters are guaranteed only over the recommended operating temperature range.

Item

Supply Voltage, VDD

All Inputs and Outputs

Ambient Operating Temperature (commercial)

Ambient Operating Temperature (industrial)

Storage Temperature

Junction Temperature

Soldering Temperature (20 seconds max)

Rating

7V

-0.5 V to VDD+0.5 V

0 to +70° C

-40 to +85° C

-65 to +150° C

125° C

260° C

Recommended Operation Conditions

Parameter

Ambient Operating Temperature (commercial)

Ambient Operating Temperature (industrial)

Power Supply Voltage (measured with respect to GND)

Min.

0

-40

+3.0

Typ.

+3.3

Max.

+70

+85

+5.5

Units

°C

°C

V

IDT™ / ICS™ NETWORKING CLOCK SOURCE

5

ICS650-07C REV D 102709

Share Link: