ISL6131 Ver la hoja de datos (PDF) - Renesas Electronics
Número de pieza
componentes Descripción
Lista de partido
ISL6131 Datasheet PDF : 15 Pages
| |||
ISL6131, ISL6132
Absolute Maximum Ratings
VDD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +6.0V
VMON, ENABLE, STATUS, PGOOD . . . . . . . . . . . . . . . . . . . -0.3V to VDD+0.3V
ESD Classification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2kV (HBM)
Operating Conditions
VDD Supply Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . .+1.5V to +5.5V
Temperature Range (TA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +85°C
Thermal Information
Thermal Resistance (Typical, Notes 4, 5)
JA (°C/W) JC (°C/W)
4x4 QFN Package. . . . . . . . . . . . . . . . . . . . .
48
9
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . .+150°C
Maximum Storage Temperature Range . . . . . . . . . . . . . .-65°C to +150°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
4. JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
5. For JC, the “case temp” location is the center of the exposed metal pad on the package underside.
6. All voltages are relative to GND, unless otherwise specified.
Electrical Specifications Nominal VDD = 1.5V to +5V, TA = TJ = -40°C to +85°C, unless otherwise specified. Boldface limits apply
over the operating temperature range, -40°C to +85°C.
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
MAX
(Note 7) TYP (Note 7) UNIT
VMON/ENABLE INPUTS
VMON Falling Threshold
VMON Threshold Temp. Coeff.
VMON Hysteresis
VMON Glitch Filter
VVMONvth
TCVMONvth
VVMONhys
Tfil
TJ = +25°C
TJ from -40°C to +85°C
619
633
647
mV
-
40
-
V/°C
-
10
-
mV
-
30
-
s
VMON Minimum Input Impedance
ENABLE L2H, Delay to STATUS & PGOOD
Zin_min TJ = +40°C, VMON within 63mV of VVMONvth
8
M
VMON valid, EN high to STATUS and PG high
-
160
-
ms
EN H2L, Delay to PGOOD
EN low to PGOOD low
-
-
0.1
s
EN H2L, Delay to STATUS
EN low to STATUS low
-
13
-
s
ENABLE Pull-up Voltage
ENABLE Threshold Voltage
STATUS/PGOOD OUTPUTS
VENVTH
EN open
-
VDD
-
V
-
VDD/2
-
V
STATUS Pull-Down Current
STATUS/PGOOD Delay after VMON Valid
STATUS/PGOOD Output Low
BIAS
IRSTpd
TdelST
Vol
RST = 0.1V
VMON > VUVvth to STATUS = 0.2V
Measured at VDD = 1.0V
-
88
-
mA
-
160
-
ms
-
0.04
0.1
V
IC Supply Current
IVDD_5.5V VDD = 5V
-
170
-
A
IC Supply Current
IVDD_3.3V VDD = 3.3V
-
145
-
A
IC Supply Current
IVDD_1.5V VDD = 1.5V
-
100
-
A
VDD Power On
VDD_POR VDD high to low
-
0.89
1
V
VDD Power On Lock Out
VDD_LO VDD low to high
-
0.91
-
V
NOTE:
7. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
FN9119 Rev 6.00
February 11, 2014
Page 4 of 15
Share Link: 