XE24S100 Ver la hoja de datos (PDF) - Xecom
Número de pieza
componentes Descripción
fabricante
XE24S100 Datasheet PDF : 16 Pages
| |||
FCC PART 15 REGULATIONS
Mounting the XE24S100 in Your Assembly
The XE24S100 must be mounted horizontally on your
printed circuit board to maintain proper orientation of
the transceiver. Standoffs should also be used on the
side opposite the pin row to maintain clearance
between the XE24S100 and you printed circuit board.
The XE24S100 may not be co-located with any other
antenna or transmitter.
XE24S100 Antenna
The XE24S100 is certified for compliance to FCC Part 15
rules only using the Xecom TBD, 1/4 wave monopole
antenna. Use of any other antenna violates FCC Part 15
rules.
FCC Part 15 Certification
The XE24S100 has been certified per FCC Part 15 rules
for integration into OEM products without further
testing or certification. This certification is your
assurance that the XE24S100 will not cause harmful
interference.
Labeling Requirements
FCC rules require the Original Equipment Manufacturer
using the XE24S100 to place an appropriate label on the
outside of the finished equipment. The label must be
clearly visible and include the information shown
below.
Contains Transmitter Module
FCC ID: TBD
WARNING:
This device complies with Part 15 of the FCC Rules.
Its operation is subject to the following conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any received interference
including interference that may cause undesired
operation.
Limitations
The XE24S100 is registered under FCC Part 15 Rules.
To utilize this registration on your OEM System you
must follow the applications circuit provided in this
data sheet and use the listed antennas. Any changes or
modifications to the recommended circuit must be
approved by Xecom. Failure to seek Xecom’s approval
for modifications could void certification of the end
product.
Warning: RF Exposure
The XE24S100 is approved for mobile, base station and
mobile applications. A minimum separation of 20
centimeters should be maintained between the antenna
and the equipment operator. For mobile applications
check the minimum separation distances defined below.
To ensure compliance, operation at distances closer
than those defined is not recommended.
The Warning message below must be included in the
user Manual for the end product.
To comply with FCC RF exposure requirements
for mobile transmitting devices, this transmitter
should only be used or installed at locations where
there is at least 20 cm separation distance between
the antenna and all persons.
FCC Notifications
The XE24S100 generates radio frequency energy. It
must be installed according to the manufacturer’s guide-
lines stated in the data sheet or it has the potential to
cause interference with other radio devices. Testing has
been performed to assure that it conforms with the FCC
Part 15 rules for intentional and unintentional radiators.
No further EMI compliance testing of the transmitter is
required as long as the 20 cm separation and co-location
requirements are observed. Each new use of the module
will, however, need to be scanned for unintentional ra-
diation from digital clocks, etc.
All necessary calibration has been performed at the time
of manufacture. Any modification of the device after it
leaves the factory is a violation of FCC rules.
XECOM
(15)
XE24S100
Share Link: 