EMC6D102(2006) Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

EMC6D102
(Rev.:2006)

Fan Control Device with Hardware Monitoring and Acoustic Noise Reduction Features

SMSC -> Microchip 

Fan Control Device with Hardware Monitoring and Acoustic Noise Reduction Features

Datasheet

5.4

Interrupt Status Registers

The Hardware Monitor Block contains two interrupt status registers: Register 41h: Interrupt Status

Register 1 on page 54 and on page 55. These registers are used to reflect the state of all temperature,

voltage and fan violation of limit error conditions and diode fault conditions that the Hardware Monitor

Block monitors.

When an error occurs during the conversion cycle, its corresponding bit is set in its respective interrupt

status register. The bit remains set until the register is read by software, at which time the bit will be

cleared to ‘0’ if the associated error event no longer violates the limit conditions or if the diode fault

condition no longer exists. Reading the register will not cause a bit to be cleared if the source of the

status bit remains active.

These registers are read only – a write to these registers have no effect. These registers default to

0x00 on VCC POR and Initialization.

See the description of the Interrupt Status registers in Chapter 7, "Register Set," on page 45.

Each interrupt status bit has a corresponding bit located in an interrupt enable register, which may be

used to enable/disable the individual event from setting the status bit. See the figure below for the

status and enable bits used to control the interrupt bits and INT# pin.

SMSC EMC6D102

21

DATASHEET

Revision 0.4 (06-15-06)

Share Link: