PE4270 Ver la hoja de datos (PDF) - Peregrine Semiconductor Corp.
Número de pieza
componentes Descripción
Lista de partido
PE4270 Datasheet PDF : 8 Pages
| |||
PE4270
Product Specification
Evaluation Kit
The PE4270 EK board was designed to ease
customer evaluation of Peregrine’s high
performance SPST CATV MOSFET switch. RF1
is connected through a 75 Ω transmission line via
the top left F connector, J1. RF2 is connected
through a 75 Ω transmission line via the top right
F connector, J2. A 75 Ω through transmission line
is available via F connectors J3 and J4. This
transmission line can be used to estimate the loss
of the PCB over the environmental conditions
being evaluated. VDD is supplied via J6-2, while
the control logic voltage is supplied via J5-2. It is
the responsibility of the customer to determine
proper supply decoupling for their design
application. It has been observed that by
removing C1 and C2 from the evaluation board
has not shown to degrade RF performance.
The board is constructed of a two metal layer FR4
material with a total thickness of 0.031”. The
bottom layer provides ground for the RF
transmission lines. The transmission lines were
designed using a coplanar waveguide model with
trace width of 0.021”, trace gaps of 0.030”,
dielectric thickness of 0.028”, metal thickness of
0.0021” and εr of 4.6. Note that the predominate
mode for these transmission lines is coplanar
waveguide with a ground plane.
Figure 11. Evaluation Board Layouts
Peregrine Specification 101/0167 (with F connectors)
Figure 12. Evaluation Board Schematic
Peregrine Specification 102/0224
Document No. 70-0148-06 │ www.psemi.com
©2005-2010 Peregrine Semiconductor Corp. All rights reserved.
Logo updated under non-rev change. Peregrine products are protected under one or more of the following U.S. Patents: http://patents.psemi.com
Page 5 of 8
Share Link: 