74AVC16836ADGG Hoja de datos - Philips Electronics
Número de pieza
74AVC16836ADGG
Fabricante
![Philips](/logo/Philips.png)
Philips Electronics
![Philips](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
DESCRIPTION
The 74AVC16836A is a 20-bit universal bus driver. Data flow is controlled by output enable (OE), latch enable (LE) and clock inputs (CP).
This product is designed to have an extremely fast propagation delay and a minimum amount of power consumption.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor (Live Insertion).
A Dynamic Controlled Output (DCO) circuitry is implemented to support termination line drive during transient. See the graphs on page 8 for typical curves.
FEATURES
• Wide supply voltage range of 1.2 V to 3.6 V
• Complies with JEDEC standard no. 8-1A/5/7.
• CMOS low power consumption
• Input/output tolerant up to 3.6 V
• DCO (Dynamic Controlled Output) circuit dynamically changes output impedance, resulting in noise reduction without speed degradation
• Low inductance multiple VCC and GND pins for minimum noise and ground bounce
• Power off disables 74AVC16836A outputs, permitting Live Insertion
• Integrated input diodes to minimize input overshoot and undershoot
• Full PC133 solution provided when used with PCK2509S or PCK2510S and CBT16292
Page Link's:
1
2
3
4
5
6
7
8
9
10
More Pages
Número de pieza
componentes Descripción
Ver
Fabricante
20-bit registered driver with inverted register enable (3-State)
NXP Semiconductors.
20-bit registered driver with inverted register enable (3-State)
Philips Electronics
20-bit registered driver with inverted register enable (3-State)
Philips Electronics
18-bit registered driver with inverted register enable and Dynamic Controlled Outputs™ (3-State)
Philips Electronics
18-bit registered driver with Dynamic Controlled Outputsâ„¢ (3-State)
NXP Semiconductors.
18-bit registered driver with inverted register enable (3-State)
Philips Electronics
18-bit registered driver with inverted register enable; 3-state
NXP Semiconductors.
18-bit registered driver with inverted register enable (3-State)
Philips Electronics
20-bit registered driver with inverted register enable and 30Ω termination resistors (3-State) ( Rev : V2 )
Philips Electronics
20-bit registered driver with inverted register enable and 30Ω termination resistors (3-State)
Philips Electronics