RTL8153
Datasheet
6.2. Customizable LED Configuration
The RTL8153 supports customizable LED operation modes via OCP address DD90h~DD91h. Table 11
describes the different LED actions.
Bit
15:12
11:8
7:4
3:0
Table 11. LED Select (OCP Register Offset DD90h~DD91h)
Symbol
RW Description
LEDCntl
RW LED Feature Control.
LEDSEL2
RW LED Select for PINLED2.
LEDSEL1
RW LED Select for PINLED1.
LEDSEL0
RW LED Select for PINLED0.
When implementing customized LEDs:
Configure OCP address DD90h to support your own LED signals. For example, if the value in the OCP
address DD90h is 0CA9h (0000110010101001b), the LED actions are:
• LED 0: On only in 10M mode, with blinking during TX/RX
• LED 1: On only in 100M mode, with blinking during TX/RX
• LED 2: On only in 1000M mode, with blinking during TX/RX
Speed
LED 0
LED 1
LED 2
Feature Control
Link 10M
Bit 0
Bit 4
Bit 8
Bit 12
Table 12. Customized LEDs
LINK
Link 100M
Link 1000M
Bit 1
Bit 2
Bit 5
Bit 6
Bit 9
Bit 10
Bit 13
Bit 14
ACT/Full
Bit 3
Bit 7
Bit 11
Bit 15
Note: There are two special modes:
LED OFF Mode: Set all bits to 0. All LED pin output become floating (power saving).
Fixed LED Mode: Set Option 1 LED table Mode: LED0=LED1=LED2=1 or 2 (see Table 13).
Bit31~Bit0 Value
1XXX 0001 0001 0001
1XXX 0010 0010 0010
Note: ‘X’ indicates ‘irrelevant’.
Table 13.
LED0
ACT
Transmit
Fixed LED Mode
LED1
LINK
LINK
LED2
Full Duplex + Collision
Receive
Integrated 10/100/1000M Ethernet Controller for USB Applications
9
Track ID: JATR-8275-15 Rev. 1.1