EM636327 Ver la hoja de datos (PDF) - Etron Technology
Número de pieza
componentes Descripción
Lista de partido
EM636327 Datasheet PDF : 78 Pages
| |||
EtronTech
EM636327
into high-impedance at the end of the burst unless other command is initiated. The burst length,
burst sequence, and CAS# latency are determined by the mode register, which is already
programmed. A full-page burst will continue until terminated (at the end of the page it will wrap to
column 0 and continue).
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
C OM M A ND
READ A
CAS# latency=1
tCK1, DQ's
CAS# latency=2
tCK2, DQ's
CAS# latency=3
tCK3, DQ's
NOP
NOP
NOP
NOP
NOP
DOUT A0 DOUT A1
DOUT A2 DOUT A3
NOP
NOP
DOUT A0 DOUT A1
DOUT A2 DOUT A3
DOUT A0 DOUT A1
DOUT A2 DOUT A3
NOP
Burst Read Operation(Burst Length = 4, CAS# Latency = 1, 2, 3)
The read data appears on the DQs subject to the values on the DQM inputs two clocks earlier
(i.e. DQM latency is two clocks for output buffers). A read burst without the auto precharge function
may be interrupted by a subsequent Read or Write/Block Write command to the same bank or the
other active bank before the end of the burst length. It may be interrupted by a BankPrecharge/
PrechargeAll command to the same bank too. The interrupt coming from the Read command can
occur on any clock cycle following a previous Read command (refer to the following figure).
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
C OM M A ND
READ A
READ B
NOP
NOP
NOP
NOP
NOP
NOP
NOP
CAS# latency=1
tCK1, DQ's
CAS# latency=2
tCK2, DQ's
CAS# latency=3
tCK3, DQ's
DOUT A0 DOUT B0
DOUT B1
DOUT B2
DOUT B3
DOUT A0 DOUT B0
DOUT B1
DOUT B2
DOUT B3
DOUT A0 DOUT B0
DOUT B1
DOUT B2
DOUT B3
Read Interrupted by a Read (Burst Length = 4, CAS# Latency = 1, 2, 3)
The DQM inputs are used to avoid I/O contention on the DQ pins when the interrupt comes
from a Write/Block Write command. The DQMs must be asserted (HIGH) at least two clocks prior to
the Write/Block Write command to suppress data-out on the DQ pins. To guarantee the DQ pins
against I/O contention, a single cycle with high-impedance on the DQ pins must occur between the
last read data and the Write/Block Write command (refer to the following three figures). If the data
output of the burst read occurs at the second clock of the burst write, the DQMs must be asserted
(HIGH) at least one clock prior to the Write/Block Write command to avoid internal bus contention.
Preliminary
7
December 1998
Share Link: 