XE5224DM Ver la hoja de datos (PDF) - Xecom

Número de pieza

componentes Descripción

Lista de partido

XE5224DM

Blackjack Tele-Controller

Xecom 

Table 3 (continued)

Command

Syntax

Description

Input

Kill Memory

Load Program

Move Program

Next

Output Data

Read File

Show

Time

UART

Version

Write Hex File

I(Port Address)

Inputs one byte specified by (Port Address). Entering a space

inputs one byte; a C causes bytes to be continuously entered.

A Carriage Return terminates the continuous mode.

K(n) <ENTER>

This command erases the designated sector of Flash

memory. Only sectors of Flash memory which are not write

protected may be erased. The message "Unkown memory

section or write protected" will be displayed if you attempt to

erase a protected area of memory.

L(Source Start Add)(Source End Add) This command loads the data from the designated

(Target Start Add)<ENTER>

program memory location into the selected data memory

address.

M(Source Start Add)(Source End Add) The "M" command moves a block of data from one data

(Target Start Add)<ENTER>

memory address to another.

N [Add]<Enter>

This command permits you to step through your application

program one instruction at a time. Step from one instruction

to the next by pressing the space bar. Enter a Carriage

Return to exit single-step operation.

O(I/O Address) (byte)<ENTER>

Output the indicated byte to the selected I/O address.

R[Offset Address] <ENTER>

The "R" command permits .Hex files to be downloaded from

the host, normally a Personal Computer. This command may

be ommited if a zero offset address is needed.

S[Register]<ENTER>

This command displays the contents of the listed register. If

no register value is listed, the contents of all registers will be

displayed.

T<ENTER>

This command is used to start the Tele-Controller's Real

Time Clock. The TC-Monitor first asks if you wish to Reset

the Real Time Clock; enter Y for yes and N for no. If you

enter No, you will return to the TC-Monitor prompt. If you

select Yes the TC-Monitor will prompt you to enter a new

Year, Month, Day, Hour and Minute.

U<ENTER>

This command permits direct communications with the

modem. This permits you to enter "AT" modem commands

directly to the modem by using terminal emulation software.

To end communications with the modem type the # character

followed by <ENTER>.

V<ENTER>

This command displays the revision level of the TC-Moniltor.

The format will be "V 1.00-ROM, Xecom, 10/10/94. Note: If

you are using an updated version of the TC-monitor stored in

Flash memory the revision level will be shown as V 1.xx-

Flash, Xecom, 1/1/95.

W(Start Add) (End Add) <ENTER>

This command is used to upload the contents of the program

memory in the controller to the host. To upload contents of

data memory into program memory it must first be loaded

into an overlapped memory section. If the listed starting

address is greater than the ending address, the TC-Monitor

will roll over to address zero when completed with address

FFFF and continue until the ending address is reached.

XECOM

(10)

XE5224DM & XE5224FD

Share Link: