ST7MDT2-EPB2 Ver la hoja de datos (PDF) - STMicroelectronics

Número de pieza

componentes Descripción

Lista de partido

ST7MDT2-EPB2

A LOW-COST DEVELOPMENT PACKAGE INCLUDING A FULL REAL-TIME EMULATION BOARD

STMicroelectronics 

3 - How to Program

ST7 EPB User Manual

6 Lift the relevant ZIF socket lever and place the device into the socket with pin 1

matching the mark on the board. Lock the device in place by lowering the lever

again.

Place your device here, making sure to

align pin 1 on the device with the arrow

on the programming board

ZIF Socket

3.1.2

7 Power on the EPB.

lever

Installing a device for programming using ISP mode

To see whether programming in ISP mode is possible for your target MCU, refer to

the MCU’s datasheet, or consult ST7_EPB.pdf, installed with the Windows

Epromer, and available by selecting Start>Programs>ST7 Toolchain>User

Manuals.

If ISP mode is supported, the datasheet will provide the connection information

necessary to set up your application board for ISP programming.

Once you have ensured that you have correctly set up your application board to

support ISP mode, and that the ST7 EPB programming board is a type that

supports ISP mode, follow these instructions:

1 Set up the EPB as described in Section 2.2 on page 7.

2 Make sure that your EPB and application board are powered off.

3 From your host PC select Start>Programs>ST7 Tool Chain> Development

Tools>Windows Epromer to launch the Windows Epromer software program.

4 Connect one end of the ISP ribbon cable to the 10-pin ISP connector on the

EPB and the other end to the same type of connector on your application board.

5 Switch on your application board.

6 Power on the EPB.

10/20

Share Link: