BD9486F Ver la hoja de datos (PDF) - ROHM Semiconductor

Número de pieza

componentes Descripción

Lista de partido

BD9486F

1ch Boost up type White LED Driver for large LCD

ROHM Semiconductor 

BD9486F

Datasheet

●3.2.6 UVLO Setting

Under Voltage Lock Out pin is the input voltage of the power stage. IC starts boost operation if UVLO is more than

3.0V(typ.) and stops if lower than 2.7V(typ.).

The UVLO pin is high impedance, because the internal resistance is not connected to a certain bias.

So, the bias by the external components is required, because the open connection of this pin is not a fixed potential.

Detection voltage is set by dividing resistors R1 and R2. The resistor values can be calculated by the formula below.

○UVLO detection equation

As VIN decreases, R1 and R2 values are set in the following formula by the VINDET that UVLO detects.

R1  R2[kΩ]  (VINDET[V]  2.7[V]) [kΩ]

2.7[V]

○UVLO release equation

R1 and R2 setting is decided by the equation above. The equation of UVLO

release voltage is as follows.

VINCAN



3.0V



(R1[kΩ]  R2[kΩ])

R2[kΩ]

[V]

【setting example】

If the normal input voltage, VIN is 24V, the detect voltage of UVLO is 18V, R2 is

30kΩ, R1 is calculated as follows.

Figure 26. UVLO setting example

R1  R2[k] (VINDET[V]  2.7[V])  30[k] (18[V]  2.7[V])  170.0 [k]

2.7[V]

2.7[V]

By using these R1 and R2, the release voltage of UVLO, VINCAN, can be calculated too as follows.

VINCAN



3.0[V] 

(R1[k]  R2[k])

R2[k]



3.0[V] 

170[k]  30[k]

30[k]

[V]　

20.0

[V]

www.rohm.com

© 2013 ROHM Co., Ltd. All rights reserved.

TSZ22111・15・001

17/34

TSZ02201-0F1F0C100240-1-2

13.Feb.2014 Rev.004

Share Link: