USB97CFDC2-MV-01X Ver la hoja de datos (PDF) - SMSC -> Microchip

Número de pieza

componentes Descripción

Lista de partido

USB97CFDC2-MV-01X

USB Floppy Disk Controller

SMSC -> Microchip 

PIN NO.

NAME

BUFFER

SYMBOL

TYPE

DESCRIPTION

18

Crystal Output XTAL2

OCLKx 14.318Mhz Crystal

This is the other terminal of the crystal, or left open

when an external clock source is used to drive

XTAL1/CLKIN. It may not be used to drive any

external circuitry other than the crystal circuit.

20

ROM Enable ROMEN

IP If this input is tied high or left open, the internal

program ROM is enabled. If tied low, external

program memory can be used for custom

applications.

24

Drive Density HDO

Output

I

In some configurations of the USB97CFDC, this

drive pin indicates if a 640/720K disk is inserted in

the drive. Polarity of this signal is determined by

the configuration selected by the OPT[3:0] pins at

reset. If this pin is not driven by the drive, it should

be tied low.

25

Drive Ready nDRVRDY

I

An active low signal on this pin from the floppy disk

drive, after DS0 goes active, indicates that the

system may activate MTR0. If the drive does not

supply this signal, this pin should be tied low.

26

Drive Power nFDPWR

OD24

This active low signal is intended to activate an

external power switch, either in the drive or on the

system board, to supply power to the floppy disk

drive. It is active whenever the USB97CFDC2-01

is not in SUSPEND mode.

21

RESET input nRESET

IS This active low signal is used by the system to

reset the chip. The active low pulse should be at

least 100ns wide.

22

Test output TSTOUT

O8 This signal is used for testing the chip via an

internal XNOR chain. User should normally leave it

unconnected.

15

Test input nTEST

I

This signal is a manufacturing test pin. It should

be tied to VDD for normal operation.

16

Test Enable nTESTEN

I

This active low signal places the device into board

test mode using the XNOR chain. For normal

operation this pin should be tied high. See Board

Test Mode Operation on page 14

POWER, GROUND, AND NO CONNECTS

14, 39, 60,

82, 93

VDD

+3.3V power

8, 19, 27, 43,

52, 66, 79,

81, 88

GND

Ground Reference

1-7, 9-13, 23,

NC

51, 78, 80,

83-87, 89-92,

94-100

No Connect. These pins should not be connected

externally.

SMSC DS – USB97CFDC2-01

Page 10

DATASHEET

Rev. 02-27-07

Share Link: