GENERAL DESCRIPTION
The AD8134 is a major advancement beyond using discrete op amps for driving differential RGB signals over twisted pair cable. The AD8134 is a triple, low cost differential or single0ended input to differential output driver, and each amplifier has a fixed gain of 2 to compensate for the attenuation of the line termination resistors. The AD8134 is specifically designed for RGB signals but can be used for any type of analog signals or high speed data transmission. The AD8134 is capable of driving either Category 5 (Cat-5) unshielded twisted pair (UTP) cable or differential printed circuit board transmission lines with minimal signal degradation.

FEATURES
   Triple high speed differential driver
      225 MHz, −3 dB large signal bandwidth
      450 MHz, −3 dB small signal bandwidth
      Easily drives 1.4 V p-p video signal into doubly terminated
         100 Ω UTP cable
      1600 V/µs slew rate
      Fixed internal gain of 2
   Internal common-mode feedback network
      Output balance error −60 dB @ 50 MHz
   On-chip sync-on-common-mode circuitry
   Output pull-down feature for line isolation
   Differential input and output
   Differential-to-differential or single-ended-to-differential
      operation
   High isolation between amplifiers: 80 dB @ 10 MHz
   Low distortion: 64 dB SFDR @ 10 MHz on 5 V supply,
      RL, dm = 200 Ω
   Low offset: 3 mV typical output-referred on 5 V supply
   Low power: 26.5 mA @ 5 V for three drivers and sync circuitry
   Wide supply voltage range: +5 V to ±5 V
   Available in space-saving packaging: 4 mm × 4 mm LFCSP
  
APPLICATIONS
   Keyboard-video-mouse (KVM) networking