[Actions Semiconductor Co., Ltd]

Description
ATJ2085 is a single-chip for flash-based digital music player. It includes an audio decoder with a high performance DSP, ADPCM record capabilities and USB interface for downloading music and uploading voice recordings. ATJ2085 also provides an interface to flash memory, LED, button and switch inputs, headphone, and microphone, and FM radio input and control.

FEATUREs
 MPEG1/2/2.5 Audio Layer 1, 2, 3 decoder
 Support WMA Decoder
 Digital Voice Recording with Actions Speech Algorithm
 24 bits DSP Core with memory and on-chip Debug Support Unit (DSU)
 Integrated 8-bit MCU with DSU
 External up to 2(cs) x 64M/128M/256M/512M/1G/2G bytes Nand type Flash accessed by MCU or DMA
 Built-in DMA, CTC (Counter/Timer Controller) and interrupt controller for MCU
 Energy saving dynamic power management (PMU)
 Support USB 2.0（FS）, Write speed(Max): 955k byte/s; Read speed(Max): 1033k byte/s
 Build in Stereo 18-bit Sigma-Delta DAC 
 Build in Key Scan Circuit (3*3) and GPIO 
 I²C interface supports Master/Slave mode, with changeable slave address 
 Support external 8080 Interface LCM driver
 Support FM Radio input and 32 levels volume control
 Support Stereo 16-bit Sigma-Delta ADC for Microphone/FM Input, sample rate at 8/12/16/22/24/32/48KHz
 MCU run at 24.576MHz(TYP), up to 60MHz 
 SNR: 90dB (DAC TYP)
 Headphone driver output 2x11mW @16 Ohm(TYP)
 Operating Voltage: IO: 3.0V(TYP), Core: 2.0V(TYP)
 Standby Leakage Current: VCC: 35uA@3.0V(TYP) , VDD: 110uA@2.0V(TYP)
 Low Power Consumption, designed for greater than 15 (TYP) hours of operation on a single battery life.  (<65mW at typical MP3 decoder solution; <90mW at typical WMA decoder solution)
64-pin (10x10mm) LQFP package