INTRODUCTION
Cermetek’s iModem® Family of Internet products are the industries first self contained modules providing a complete PSTN internet communication solution. Further, the iModem® can operate autonomously without the need for host processor intervention.

FEATURES
• Uses Point-to-Point Protocol (PPP) with Password Authentication Protocol (PAP) to connect to the Internet.
• Uses TCP/IP and Simple Mail Transfer Protocol (SMTP) to send emails.
• On Demand and event driven email transmission and reception.
• Programmable using serial interface or using PSTN.
• Remote programming using PSTN.
• Supports V.90, V.34bis, V.34, V.32, V.22bis, V.22A/B, V.23, V.21, Bell 212A and 103.
• Supports V.80 Synchronous operation.
• Error correcting: V.42 LAMP, MNP 2-4 and MNP10.
• Data Compression: V.42bis and MNP5.
• MNP10 Data throughout enhancement for cellular operation.
• DTE serial interface with speeds up to 230.4kbps.
• Automative baud rate adaptability utilizing speed sensing, flow control and data buffers.
• Send & Receive FAX Class 1, Group 3 supported.
• Serial V.24, 5 volt interface.
• NVRAM directory and stored profiles.
• Standard AT Command structure with extensions.
• Cermetek iNet AT® Command extensions.
• Built-in DAA with 1500 VAC RMS isolation 2122V peak surge protection.
• UL 1950 and CSA C22.2 950 (Third Edition) Listed, Reference UL File E104957.
• FCC Part 68 Approved/DOT CSA CS-03 Part I Approvable.
• Pin for Pin compatible with CH179X and HS Family of modems.
• +5 Volt operation with zero power option.
• Small size: 1.35” x 1.97” x 0.61” (nominal).