Description
The IRS2980S utilizes International Rectifiers control and high-voltage technologies to realize a simple, high-performance Buck LED driver solution. This solution is based on hysteretic output current regulation typically operating from 25 kHz to 120 kHz. Frequency and duty cycle vary to maintain a tightly regulated average output current over variations in line and load. Output current ripple will depend on inductor selection in conjunction with input and output voltages as well as output current and component selection. The IRS2980S uses a unique floating high side differential current sense and level shift scheme allowing hysteretic operation with a low side switching MOSFET optimizing size and cost. In addition, the IRS2980S includes a high voltage regulator able to operate up to 450V eliminating the need for an external VCC supply. A PWM dimming interface is also included that can be controlled from a 0 to 2V analog or 3.3 or 5V logic control signal able to operate up to 1kHz offering brightness control from 0 to 100%. A programmable on board PWM oscillator is used with DC dimming control.
IC Features
• Dimming LED driver controller
• Hysteretic Current Regulation
• Closed-loop LED current dimming control
• Analog/PWM Dimming Input
• Internal High Voltage Regulator
• Internal 15.6V zener clamp diode on Vcc
• Micropower startup (250μA)
• Latch immunity and ESD protection
LED Driver System Features
• Single chip dimming solution
• Simple LED current dimming control method
• No external protection circuits required (fully internal)
• Low external component count
• Easy to use for fast design cycle time
• Increased manufacturability and reliability
Typical applications
• LED incandescent/CFL replacement lamps
• LED driver module