GENERAL DESCRIPTION
The IS25LD512/010/020 are 512Kbit/ 1Mbit / 2Mbit Serial Peripheral Interface (SPI) Flash memories, providing single- or dual-output. The devices are designed to support a 33 MHz clock rate in normal read mode, and 100 MHz in fast read, the fastest in the industry. The devices use a single low voltage power supply, wide operating voltage ranging from 2.3 Volt to 3.6 Volt, to perform read, erase and program operations. The devices can be programmed in standard EPROM programmers.

FEATURES
• Single Power Supply Operation
   - Low voltage range: 2.3 V – 3.6 V
• Memory Organization
   - IS25LD512: 64K x 8 (512 Kbit)
   - IS25LD010: 128K x 8 (1 Mbit)
   - IS25LD020: 256K x 8 (2 Mbit)
• Cost Effective Sector/Block Architecture
   - 512Kb : Uniform 4KByte sectors / Two uniform
      32KByte blocks
   - 1Mb : Uniform 4KByte sectors / Four uniform
      32KByte blocks
   - 2Mb : Uniform 4KByte sectors / Four uniform
      64KByte blocks
• Low standby current 1uA (Typ)
• Serial Peripheral Interface (SPI) Compatible
   - Supports single- or dual-output
   - Supports SPI Modes 0 and 3
   - Maximum 33 MHz clock rate for normal read
   - Maximum 100 MHz clock rate for fast read
• Page Program (up to 256 Bytes) Operation
   - Typical 2 ms per page program
• Sector, Block or Chip Erase Operation
   - Maximum 10 ms sector, block or chip erase
• Low Power Consumption
   - Typical 10 mA active read current
   - Typical 15 mA program/erase current
• Hardware Write Protection
   - Protect and unprotect the device from write
      operation by Write Protect (WP#) Pin
• Software Write Protection
   - The Block Protect (BP2, BP1, BP0) bits allow
      partial or entire memory to be configured as readonly
• High Product Endurance
   - Guaranteed 200,000 program/erase cycles per
      single sector
   - Minimum 20 years data retention
• Industrial Standard Pin-out and Package
   - 8-pin 150mil SOIC
   - 8-pin VVSOP
   - 8-contact WSON
   - 8-pin TSSOP
   - 8-pin USON
   - Lead-free (Pb-free) package
• Security function
   - Build in Safe Guard function and sector unlock
      function to make the flash Robust (Appendix1&2)