General Information
TLE4926C is an active Hall sensor suited to detect the motion and position of ferromagnetic and permanent magnet structures. An additional self-calibration module has been implemented to achieve optimum accuracy during normal running operation. It comes in a three-pin package for the supply voltage and an open drain output.

FEATUREs
• High sensitivity
• Single chip solution
• Symmetrical thresholds
• High resistance to Piezo effects
• Advanced performance by dynamic self calibration principle
• South and north pole pre-induction possible
• 1Hz low cut-off frequency
• Digital output signal
• Two-wire and three-wire configuration possible
• Wide operating temperature range
• Fast start-up time
• Large operating airgaps
• Reverse voltage protection at Vs- PIN
• Short- circuit and over temperature protection of output
• No external filter capacitor required
• Digital output signal (voltage interface)
• Module style package with two integrated capacitors:
   • 4.7nF between Q and GND
   • 47nF1 between VS and GND: Needed for micro cuts in power suply
• High temperature profile
• Package: PG-SSO-3-91 with nickel plating instead of standard 100% Sn plating