Low Power NTSC/PAL/SECAM Video Decoder with VBI Slicer
FEATUREs
Video Decoder
NTSC (M, 4.43) and PAL (B, D, G, H, I, M, N, N combination), PAL (60), SECAM support with
automatic format detection
Software selectable analog inputs allow any of the following combinations, e.g. 4 CVBS or (3
CVBS and 1 Y/C).
Built-in analog anti-alias filter
Two 10-bit ADCs and analog clamping circuit
Fully programmable static gain or automatic gain control for the Y channel
Programmable white peak control for the Y channel
4-H adaptive comb filter Y/C separation
PAL delay line for color phase error correction
Image enhancement with peaking and CTI.
Digital sub-carrier PLL for accurate color decoding
Digital Horizontal PLL for synchronization processing and pixel sampling
Advanced synchronization processing and sync detection for handling non-standard and weak
signal
Programmable hue, brightness, saturation, contrast, and sharpness.
Automatic color control and color killer
Chroma IF compensation
ITU-R 601 or ITU-R 656 compatible YCbCr(4:2:2) output format
VBI slicer supporting industrial standard data services
VBI data pass through, raw ADC data output
Video Scaler
High quality horizontal filtered scaling with arbitrary scale down ratio
Phase accuracy better than 1/32 pixel
Programmable output cropping
Miscellaneous
Two wire MPU serial bus interface
Support Real Time Control interface
Power save and Power down mode
Typical power consumption <100mW
Single 27MHz crystal for all standards
Supports 24.54MHz and 29.5MHz crystal for high resolution square pixel format decoding
3.3V tolerant I/O
1.8V/3.3 V power supply
44 pin LQFP, 48 pin QFN package