datasheetbank_Logo
búsqueda de Hoja de datos y gratuito Fichas de descarga
HOME  >>>  Winbond  >>> W83877TF PDF

W83877TF(1998) Hoja de datos - Winbond

W83877TF image

Número de pieza
W83877TF

componentes Descripción

Other PDF
  lastest PDF  

PDF
DOWNLOAD     

page
154 Pages

File Size
575.1 kB

Fabricante
Winbond
Winbond Winbond

GENERAL DESCRIPTION
The W83877TF is an enhanced version from Winbonds most popular I/O chip W83877F --- which
integrates the disk drive adapter, serial port (UART), IrDA 1.0 SIR, parallel port, configurable Plug-and-Play registers for the whole chip --- plus additional powerful features: ACPI / legacy power
management, serial IRQ, and IRQ sharing.


FEATURES
General:
• Plug & Play 1.0A Compliant
• Support 8 IRQs (ISA), or 15 IRQs (Serial IRQ), 3 DMA channels, and 480 re-locatable address
• Capable of ISA Bus IRQ Sharing
• Comply with Microsoft PC 97 Hardware Design Guide
• Support DPM (Device Power Management), ACPI
• Report ACPI status interrupt by SCI signal from SCI pin, serial IRQ IRQSER pin, or IRQ A~H pins
• Single 24MHz/48MHZ clock input

FDC:
• Compatible with IBM PC AT disk drive systems
• Variable write pre-compensation with track selectable capability
• DMA enable logic
• Supports floppy disk drives and tape drives
• Detects all overrun and underrun conditions
• Built-in address mark detection circuit to simplify the read electronics
• FDD anti-virus functions with software write protect and FDD write enable signal (write data signal was forced to be inactive)
• Supports up to four 3.5-inch or 5.25-inch floppy disk drives
• Completely compatible with industry standard 82077
• 360K/720K/1.2M/1.44M/2.88M format;250K, 300K, 500K, 1M, 2M bps data transfer rate
• Supports vertical recording format
• Support 3-mode FDD, and its Win95 driver
• 16-byte data FIFOs

UART:
• Two high-speed 16550 compatible UARTs with 16-byte send/receive FIFOs
• MIDI compatible
• Fully programmable serial-interface characteristics:
   - 5, 6, 7 or 8-bit characters
   - Even, odd or no parity bit generation/detection
   - 1, 1.5 or 2 stop bits generation
• Internal diagnostic capabilities:
   - Loop-back controls for communications link fault isolation
   - Break, parity, overrun, framing error simulation
• Programmable baud generator allows division of 1.8461 MHz and 24 MHz by 1 to (216-1)
• Maximum baud rate is up to 921k bps for 14.768MHz and 1.5M bps for 24MHz

Infrared:
• Supports IrDA version 1.0 SIR protocol with maximum baud rate up to 115.2K bps
• Supports SHARP ASK-IR protocol with maximum baud rate up to 57600 bps

Parallel Port:
• Compatible with IBM parallel port
• Supports PS/2 compatible bi-directional parallel port
• Supports Enhanced Parallel Port (EPP) - Compatible with IEEE 1284 specification
• Supports Extended Capabilities Port (ECP) - Compatible with IEEE 1284 specification
• Extension FDD mode supports disk drive B; and Extension 2FDD mode supports disk drives A and B through parallel port
• Enhanced printer port back-drive current protection

Others:
• Programmable configuration settings
• Immediate or automatic power-down mode for the power management
• All hardware power-on settings have internal pull-up or pull-down resistors as default value
• Dedicated Infrared Communication Pins

Package:
• 100-pin QFP (W83877TF), and also 100-pin LQFP (W83877TD)

Page Link's: 1  2  3  4  5  6  7  8  9  10  More Pages 

Número de pieza
componentes Descripción
PDF
Fabricante
WINBOND I/O
Ver
Winbond
WINBOND I/O ( Rev : 1998 )
Ver
Winbond
WINBOND I/O ( Rev : 2003 )
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond
WINBOND I/O
Ver
Winbond

Share Link: GO URL

EnglishEnglish Korean한국어 Chinese简体中文 Japanese日本語 Russianрусский

All Rights Reserved© datasheetbank.com  [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]