SM8135B Ver la hoja de datos (PDF) - Nippon Precision Circuits

Número de pieza

componentes Descripción

Lista de partido

SM8135B

White LED Driver IC

Nippon Precision Circuits  

SM8135B

Boost Mode Auto-switching

The SM8135B switches between ×1.0 mode (VIN through mode), ×1.5 mode (1.5-times charge pump boost),

and ×2.0 mode (2.0-times charge pump boost) automatically in response to the operating state to reduce current

consumption. The switching transition flow chart is shown in the following figure.

LED ON

1.0 mode

1.5 mode

ILED judgment

sufficient

insufficient

ILED judgment

insufficient

sufficient

1.5 mode

2.0 mode

1.0sec

1.0sec

Mode reset

1.5 1.0

Mode reset

2.0 1.5

ILED judgment

ILED judgment

sufficient

sufficient

insufficient

insufficient

Boost mode switching flow chart

This section describes the boost mode switching in response to insufficient LED drive current level detection.

The next section describes the mode reset functions. Initially, when the LED drive current begins to flow, oper-

ation begins in ×1.0 mode at the set current value if possible, without boosting the input voltage VIN. If the set

current value cannot be attained in ×1.0 mode due to a VIN voltage drop or an increase in the set current value,

a low-current detector circuit connected to each LED drive circuit is activated that switches the VOUT output

to ×1.5 mode automatically, and the charge pump circuit starts boosting the voltage by 1.5 times. If the set cur-

rent value still cannot be attained, the LED drive circuits are switched to ×2.0 mode, and the charge pump starts

boosting the voltage by 2 times.

SEIKO NPC CORPORATION —9

Share Link: