General description
The LPC2388 microcontroller is based on a 16-bit/32-bit ARM7TDMI-S CPU with real-time emulation that combines the microcontroller with 512 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at the maximum clock rate. For critical performance in interrupt service routines and DSP algorithms, this increases performance up to 30 % over Thumb mode. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty.

FEATUREs and benefits
■ ARM7TDMI-S processor, running at up to 72 MHz.
■ Up to 512 kB on-chip flash program memory with In-System Programming (ISP) and In-Application Programming (IAP) capabilities. Flash program memory is on the ARM local bus for high performance CPU access.
■ 64 kB of SRAM on the ARM local bus for high performance CPU access.
■ 16 kB SRAM for Ethernet interface. Can also be used as general purpose SRAM.
■ 16 kB SRAM for general purpose DMA use also accessible by the USB.
■ Dual Advanced High-performance Bus (AHB) system that provides for simultaneous Ethernet DMA, USB DMA, and program execution from on-chip flash with no contention between those functions. A bus bridge allows the Ethernet DMA to access the other AHB subsystem.
■ EMC provides support for static devices such as flash and SRAM as well as off-chip memory mapped peripherals.
■ Advanced Vectored Interrupt Controller (VIC), supporting up to 32 vectored interrupts.
■ General Purpose DMA controller (GPDMA) on AHB that can be used with the SSP serial interfaces, the I2S-bus port, and the Secure Digital/MultiMediaCard (SD/MMC) card port, as well as for memory-to-memory transfers.
■ Serial Interfaces:
    ◆ Ethernet MAC with associated DMA controller. These functions reside on an independent AHB.
    ◆ USB 2.0 device/host/OTG with on-chip PHY and associated DMA controller.
    ◆ Four UARTs with fractional baud rate generation, one with modem control I/O, one with IrDA support, all with FIFO.
    ◆ CAN controller with two channels.
    ◆ SPI controller.
    ◆ Two SSP controllers, with FIFO and multi-protocol capabilities. One is an alternate for the SPI port, sharing its interrupt and pins. These can be used with the GPDMA controller.
    ◆ Three I2C-bus interfaces (one with open-drain and two with standard port pins).
    ◆ I2S (Inter-IC Sound) interface for digital audio input or output. It can be used with the GPDMA.
(Continue ...)

APPLICATIONs
■ Industrial control
■ Medical systems
■ Protocol converter
■ Communications