General Description
The A49LF040A flash memory device is designed to be read-compatible with the Intel Low Pin Count (LPC) Interface Specification 1.1. This device is designed to use a single low voltage, range from 3.0 Volt to 3.6 Volt power supply to perform in-system or off-system read and write operations. It provides protection for the storage and update of code and data in addition to adding system design flexibility through five general-purpose inputs. Two interface modes are supported by the A49LF040A: Low Pin Count (LPC) Interface mode for In-System programming and Address/Address Multiplexed (A/A Mux) mode for fast factory programming of PC-BIOS applications.

FEATURES
• Single Power Supply Operation
    - Low voltage range: 3.0 V - 3.6 V for Read and Write Operations
• Standard Intel Low Pin Count Interface
    - Read compatible to Intel® Low Pin Count (LPC) interface
• Memory Configuration
    - 512K x 8 (4 Mbit)
• Block Architecture
    - 4Mbit: eight uniform 64KByte blocks
    - Supports full chip erase for Address/Address Multiplexed (A/A Mux) mode
• Automatic Erase and Program Operation
    - Embedded Byte Program and Block/Chip Erase algorithms
    - Typical 10 µs/byte programming time
    - Typical 1s block erase time
• Two Operational Modes
    - Low Pin Count Interface (LPC) Mode for in-system operation
    - Address/Address Multiplexed (A/A Mux) Interface Mode for programming equipment
• Low Pin Count (LPC) Mode
    - 33 MHz synchronous operation with PCI bus
    - 5-signal communication interface for in-system read and write operations
    - Standard SDP Command Set
    - Data Polling (I/O7) and Toggle Bit (I/O6) features
    - Block Locking Register for all blocks
    - 4 ID pins for multi-chip selection
    - 5 GPI pins for General Purpose Input Register
    - TBL pin for hardware write protection to Boot Block
    - WP pin for hardware write protection to whole memory array except Boot Block
• Address/Address Multiplexed (A/A Mux) Mode
    - 11-pin multiplexed address and 8-pin data I/O interface
    - Supports fast programming on EPROM programmers
    - Standard SDP Command Set
    - Data Polling (I/O7) and Toggle Bit (I/O6) features
• Lower Power Consumption
    - Typical 12mA active read current
    - Typical 24mA program/erase current
• High Product Endurance
    - Guarantee 100,000 program/erase cycles for each block
    - Minimum 20 years data retention
• Compatible Pin-out and Packaging
    - 32-pin (8 mm x 14 mm) TSOP (TYPE I)
    - 32-pin PLCC
    - Optional Pb-free (Lead-free) package
    - All Pb-free (Lead-free) products are RoHS compliant